UNIROLL shaft motor set Comfort maxi Type 4 D-23100

Uniroll shaft motor set type 4 D-23100 Comfort maxi

The Uniroll shaft motor type 4 is a patented quality product made in Germany. Easy to install in the roller shutter box with drilling template: put the shaft adapter on the motor pin and push it into the 60mm shaft, the shaft now has double ball bearings on this side. End points, intermediate positions and all other settings are easily made on the control unit. It is no longer necessary to open the roller shutter box after installation.

Electrical work is also not necessary: the control can also be connected using a Euro plug, the control cable to the shaft motor is pluggable. Also ideal for retrofitting - the mounting plate of the control perfectly covers an existing belt box. With the convenient 3-button operation of the COMFORT control, you can effortlessly set the daily raising and lowering times of your roller shutter. The roller shutter can also be operated manually at any time when the time control is switched on. Connect the sun sensor provided and your plants and furniture are protected from too much sunlight. The sun automatic function raises your roller shutter again when the brightness of the sun sensor falls below the factory-set response brightness - this can be changed if desired.

Would you like to operate your roller shutter remotely? No problem! The optionally available radio receiver module can be retrofitted at any time: simply insert it into the COMFORT control and connect it to the Uniroll 1-channel or 5-channel hand-held transmitter at the touch of a button - done!

Advantages:

• No electrical work in the roller shutter box
• shaft motor with 24V safety low voltage
• Power supply and control from the control unit through simple plug connection

Technical data:

• Set No.: D-23100
• Supply voltage: 230 VAC 50 Hz
• Operating voltage: 24 V
• Tensile force: max 35 kg / 350 N
• Torque: 17 Nm
• Power: max. 70 W
• Power in idle mode: approx. 1 W
• Short-term operation: max. 5 minutes
• Protection class: II
• shaft motor: IP44
• Control panel: IP 20
• Mains connection: H03 VV-F 2 x 0.75 with Euro plug or direct connection
• Material: Recyclable
• Test mark: LGA/GS,
• Dimensions control panel: 210.00 x 60.60 x 48.00 mm (H x W x D) Dimensions shaft motor: 156.00 x 150.00 x 44.00 mm (H x W x D)

Tags: Motor for roller shutters, lintel roller shutters, electric roller shutters, roller shutter automation, motor for blinds, roller shutter system, motor with shaft, quiet motor for roller shutters